Clik here to view.
Infill printed outside object
Hi All, First a small introduction. I'm a newbie in the 3d printing world and started to built my own printer a few months ago. It's based on a Prusa i3, but the frame is built with heavy extruision...
View ArticleRe: Infill printed outside object
This is a wild guess, but have you somehow specified 2 extruders, with one extruder for the infill?
View ArticleRe: Infill printed outside object
I think you may have a calibration problem somewhere - that object would normally be in the centre of the bed when printing.
View ArticleRe: Infill printed outside object
Thank you both for your reply. There is only extruder specified. The thing Waitiki noticed could be an issue. I will look into that and report back.
View ArticleRe: Infill printed outside object
It turns out to be a glitch in the firmware. I made new files with the online generator of repetier and it worked out fine until there was another layer shift. But that had something to do with the...
View ArticleClik here to view.
Infill printed outside object
Hi All, First a small introduction. I'm a newbie in the 3d printing world and started to built my own printer a few months ago. It's based on a Prusa i3, but the frame is built with heavy extruision...
View ArticleRe: Infill printed outside object
This is a wild guess, but have you somehow specified 2 extruders, with one extruder for the infill?
View ArticleRe: Infill printed outside object
I think you may have a calibration problem somewhere - that object would normally be in the centre of the bed when printing.
View ArticleRe: Infill printed outside object
Thank you both for your reply. There is only extruder specified. The thing Waitiki noticed could be an issue. I will look into that and report back.
View ArticleRe: Infill printed outside object
It turns out to be a glitch in the firmware. I made new files with the online generator of repetier and it worked out fine until there was another layer shift. But that had something to do with the...
View Article
